marlex Hidroderm

Description.

Hidroderm® Dressing extra thin hydrocolloid, auto attachment, with or without external, sterile and disposable, layer made to base carboxy-methylcellulose.

Technical specifications.

Soft consistency, attachment to the skin, free of foreign material, uniform surface.

pH: 3.0 a 6.0

Water absorbency: Greater than 300 mg/ cm2

Dimensions: Nominal + 0.5 complies with evidence of systemic injection, cutaneous reactivity, irritability to skin (according to ISO 10993)

Esterilización: Ethylene oxide (ISO 11135).

Indicacions.

Dressings are used in stages of granulation and with scarce or medrados exudates.

They are placed on plates of necrosis injected inside with hydrogels to accelerate debridement lytic auto.

They are protectors against risk of friction of wounds.

It is used in the healing of injuries such as:

  • Full and partial thickness lesions.
  • Arterial, venous and diabetic leg ulcers.
  • Pressure sores.
  • Postoperative injuries.
  • Ulcers fungus.

Codes. SSA Internal Key. Length.
060 088 0652 7501802101696 10.0 cm x 10.0 cm
060 088 0660 15.0 cm x 16.0 cm
060 088 0686 7501802101641 15.0 a 21.0 cm x 15.0 a 21.0 cm
7501802101757 20.0 x 20.0 cm
7501802101740 10.0 cm x 20.0 cm

Composed of sodium carboxy-methylcellulose that allow gas exchange.

Waterproof and flexible form.

It is a non-absorbable substance which absorbs water through the mediation of the sodium ion and increases volume.

In the treatment of the ulcers creates a humid and warm atmosphere, because of the gelling of the dressing and increased its volume by contact with the bed of the wound with own exudate, characterized by its
change of color, odor caused by debridement lytic auto making during its maintenance in the lesion stimulate angiogenesis, keratinocyte proliferation and differentiation of the fibroblast.

Minimal dressing changes, can be placed up to 7 days, depending on the nature of the injury and the level of exudate.

Dressings are used in stages of granulation and with scarce or medrados exudates.

They are placed on plates of necrosis injected inside with hydrogels to accelerate debridement lytic auto.

They are protectors against risk of friction of wounds.

Damp environment favors the lytic auto debridement (removal of tissue died, tissue necrotic or devitalized and detachment).

Therefore the appearance of this hydrocolloid is yellow appearance, by the pectin and the smell is foul in the decomposition of dead cells that are pulling away from the wound.

When the wound exudate goes beyond the edges and begins to drain is indicating that it is time to remove and clean the wound (at that time and after the toilet wound more bleeding and bright red maybe a little bigger to see which is normal because we are from) (sbridando automatically wound).

Provides a suitable environment for the growth of fibroblasts (cells that form tissue granulation and epithelialization) and in this way the wound starts to heal the wound from the outside edges toward the center of the wound, forming new skin.

A wound-healing time depends on the pathology of the patient, the nutrition, the continuous changes of position in the patient bedridden, if you are diabetic or hypertensive.

  • It has guaranteed sterility unless the product has been damaged or opened before use, this device is for single use only, the physical properties of the device can no longer be in their optimum condition for its intended use.
  • During his trial in the wound removes all cell dead or devitalized this could show the largest wound after the first changes, and dismisses a bad smell (foul) this is by the decomposition of dead cells which were withdrawing from the wound that a After the toilet smell disappears and until the wound is new fabric odor disappears and the tissue shown bleeding red and healing.
  • Consult a health care professional if you notice irritation, maceration, hyper granulation or sensitivity in the wound or unexpected symptoms.

Directions for use:

 Read carefully the instructions for use contained in the instructions before application.

  1. clean / debride the lesion according to local clinical Protocol.
  2. Check that you go around the skin is clean, dry and free of grease, soaps or detergents.
  3. Assess the injury to select proper size and shape dressing. Ensure that minimum is an edge of 2-3 cm of dressing around the pot of the lesion. It is not necessary to cut the dressing to the size and shape of the lesion.
  4. Apply the dressing HIDRODERM centrally about the injury, leaving approximately a piece of 2-3 cm out of the cavity.
  5. Apply a secondary dressing suitable cavities exposed to friction on Hidroderm®.

Apósito o Parche Hidrocoloide 15x16


Hidroderm®

Marlex HC S. de R.L de C.V.

 Monday to Friday  8:00 to 18:00 Hrs.
(UTC-06:00) México City
Periferico Poniente #4360 
Col. San Juan de Ocotan  Zapopan, Jalisco C.P.45019.
Phone: +52 (33) 3832-6264
This email address is being protected from spambots. You need JavaScript enabled to view it.

Sales.

Phone: +52 (33) 3832-6264 Ext. (401) (402) (403)

 This email address is being protected from spambots. You need JavaScript enabled to view it.
This email address is being protected from spambots. You need JavaScript enabled to view it.
This email address is being protected from spambots. You need JavaScript enabled to view it.

Human resources.

Monday to Friday  8:00 to 18:00 Hrs.
(UTC-06:00) México City.
Phone: +52 (33) 3832-6264 Ext. (105)
This email address is being protected from spambots. You need JavaScript enabled to view it.
This email address is being protected from spambots. You need JavaScript enabled to view it.

Quality.

 Monday to Friday  7:00 to 15:00 Hrs 
(UTC-06:00) México City
Phone: +52 (33) 3832-6264 Ext. (502)
This email address is being protected from spambots. You need JavaScript enabled to view it.